联系我们

地址:无锡市梁溪区广益路
哥伦布广场A座
电话:0510-80218295
手机:15052137421

您当前的位置: 首页 > 新闻资讯

气动V型调节阀用途与特点

来源:气动阀门时间:2016-11-14 点击量:

原文:
Fault position must be no output pressure: 1. No signal pressure, pneumatic regulator malfunction; (2) signal of pipeline leak a lot. 2. Corrugated pipe of air leakage, repair soldering or replace 3. No gas pressure or gas supply pressure is too low. 4. Corrugated pipe orifice plug, use unblock is less than 0.2 mm diameter wire. 5. Locator zero position adjustment wrong, namely baffle and nozzle gap is too big. Use tools to adjust. 6. CAM installation position error. Because a CAM respectively containing gas with open and closed type of breath, percentage; Gas open and closed type linear characteristic gas, there are four mounting holes, easy to misplace. 7. Baffle and the nozzle end face is not vertical, baffles are still a lot of exhaust after contact with the nozzle end face. 8. The nozzle hole end there are potholes, need to change. Face a burr, regrinding. 9. The nozzle and the pedestal it leak.气动V型调节阀用途与特点.
译文:
故障一定位器无输出压力:1.无信号压力,①气动调节器故障;②信号管线大量漏气。2.波纹管大量漏气,补焊锡或更换3.无供气压力或者供气压力过低。4.波纹管节流孔堵塞,使用直径小于0.2mm的金属丝进行疏通。5.定位器零点位置调节不妥,即挡板与喷嘴间隙太大。使用工具重新调节。6.凸轮安装位置错误。因为一个凸轮分别包含气开式与气关式等百分比;气开式与气关式线性特性,有四个安装孔,容易装错。7.挡板与喷嘴端面不垂直,挡板与喷嘴端面接触后仍然大量排气。8.喷嘴孔端面有凹坑,需要更换。端面有毛刺,重新研磨。9.喷嘴与基座粘接处漏气。气动V型调节阀用途与特点.

想了解更多关于气动角座阀,角座阀,气动球阀,气动阀门,气动薄膜阀的相关信息,请持续关注无锡市气动阀门有限公司官网www.yrburkert.com

网站首页 | 关于我们 | 产品中心 | 新闻资讯 | 联系我们 | 网站地图html/xml 产品:气动球阀 气动蝶阀 气动角座阀 气动截止阀 活接 疏水阀 气动薄膜阀
Copyright@2015版权所有:无锡市气动阀门有限公司 地址:无锡市梁溪区广益路哥伦布广场 电话:0510-80218295 孙经理:15052137421 网站建设:锡企动力